Home / Extras / Checklists / Determining data loss severity on FAT volumes

Determining data loss severity on FAT volumes

	Applicability
	This checklist should be completed when estimating failure severity after a catastrophic event caused by the undetermined reason. If the reason that caused the failure is known, it is usually possible to deduce severity without reviewing the drive itself. Running through this checklist provides preliminary estimation, which is subject to change as additional information is gathered.

	Required tools
	All items are required unless explicitly stated otherwise. MS-DOS boot disk (or bootable CD) Norton DiskEditor

	The procedure
	System must run at its rated frequency (i.e. no overclocking) Check if a drive geometry and access mode (i.e. LBA) in BIOS Setup are correct. Check if drive is physically OK (no enormous scratching or clicking sounds and so on). Reviewing of S.M.A.R.T. information is recommended, but not required. If some symptoms suggest a physical damage, this checklist should be aborted and drive image must be taken as soon as possible. Boot (use boot floppy, do not attempt to boot from the affected hard disk). When booting from floppy disk, perform a cold restart, then enter BIOS setup and check if boot sequence setting is correct (i.e. floppy drive goes first). This is done to ensure that there was no tampering with boot sequence (some viruses are known to do that). Manually inspect a partition table for correctness. If a partition table is not correct, assume the disk contained a single volume starting at absolute sector 63 (most common location for 1st volume boot sector). Manually inspect boot sectors for all volumes. Manually inspect first FAT for all volumes (at least five FAT sectors should be reviewed). Inspection of second FAT is recommended but not required. Manually inspect root directories for all volumes. Inspection of root directory clusters numbered >2 on FAT32 is not required. The following table should then be used to estimate severity of the failure. Partition table Boot record FAT Root directory Severity OK OK OK OK Low OK OK OK Damaged Low OK OK Damaged Don't care Medium to high OK Damaged OK Don't care Low OK Damaged Damaged Don't care Medium to High Damaged OK OK OK Low Damaged OK Damaged Don't care Medium to high Damaged Damaged Damaged Don't care High to critical

<<

Actions to be performed when data loss is discovered

Checklists

ZAR Tip: Enjoy your cocktails in the meanwhile.

There are currently 51 visitors browsing the site.