|
|
|||||||
| ZAR ZAR-related questions. Digital image recovery; General data recovery (filesystems and RAIDs). |
 |
|
|
Thread Tools | Search this Thread | Display Modes |
|
#1
6th August 2009
|
|||
|
|||
RAID Recovery - Program Failure
Hi,
I am trying to recover a JBOD Spanned drive, which consists for 4 disk images - 1.4TB, 1.5TB, 2.7TB and 1.4TB. I try an automatic scan and it takes about 4 days and then the program just closes. I also try to define the disks manually, but it is not allowing me to specify any of the disk to be of any size other than 1. What should I do? -Anand 
|
|
#2
7th August 2009
|
|||
|
|||
|
Re: RAID Recovery - Program Failure
This does not look like a hardware JBOD, correct?
What was the original configuration and what filesystems are on that array? Also, please note that ZAR does not support JBOD recovery in automatic mode. As far as inpit is concerned, I've just checked and it worked fine for me. It does not allow to set a stripe size more than 1, which is a correct behavior (there are no stripes in JBOD). Could you please get me a screenshot of the "Define RAID manually" window (either attach here or email to development@z-a-recovery.com).
__________________
Best regards, Alexey
|
|
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Software RAID-5 Recovery | bsnaukensu | ZAR | 5 | 16th July 2009 08:27 |
| Can ZAR help me? -RAID 0 recovery | NeverEatAlone | ZAR | 1 | 26th May 2009 13:37 |
| Raid 5 array gone after power failure | Michiel | ZAR | 4 | 27th March 2009 13:52 |
| Zero Microsoft Outlook PST after MFT Master File Table Index Failure on a RAID system | Illuminator | ZAR | 0 | 14th March 2009 00:36 |
| Raid 5 unallocated disk after failure | britac | ZAR | 5 | 31st January 2008 12:05 |
Linear Mode
